Line beam provides high-speed, high-precision measurement of height and width

These sensors can be used on any manufacturing line to perform the shape measurements required for quality management of parts and materials. With the FASTUS LS series, high-accuracy 2D measurement sensor achieved both super cost effectiveness and significantly high speed measurement that conventional 1D measurement sensors can’t achieve.
These are next generation 2D displacement sensors that have created a whole new category in part measurement.

• High speed, compact size and low price are achieved using Optex-FA original method

  Employing a mathematical operation known as a projection transformation, which converts a captured image into distance, allows both height and width to be measured with a high degree of precision. Also, by employing Optex-FA original method in which projection transformations, normally performed on all pixels in the case of competitors’ products, are performed after triangulation, processing levels are significantly compressed, allowing high speed to be achieved. Furthermore, a more compact and low cost product has been realized by making processors smaller size.

• 

• Easy Setup

  The LS Series can be configured in four easy steps: imaging, profile, area measurement,amd calculation, and result judgment and output

  

• ==> APLLICATION

• • Brake pad part height measurements

    

    The relative position (height) of the tip of a brake pad wear indicator and the brake pad surface is measured.

  • Substrate overlap feed detection

    

    As opposed to a displacement sensor in which thickness measurements are performed using two substrates on top of one another, LS series sensors can measure one substrate from the lateral direction, enabling feasibility in terms of both mounting and designing.

  • Inspection for sealant application position/amount

    

    By measuring both width and height immediately following application, feedback can be quickly provided regarding the appropriate application amount and position.

  • Inspection of vehicle door gaps/height differences

    

    In order to confi rm accuracy when installing doors on vehicles, non-contact measurements are performed quickly using the gaps and height differences between the doors and vehicle body.